Wednesday, 5 September 2012

Shifting Gears

The shift lever for the Honda BF5 is located on the starboard side of the outboard motor.  This is not exactly conveniently located when the motor is mounted on the Chebacco considering the distance to the transom for the cockpit.  Add in the mizzen mast, main sheet traveller and boom gallows to make the reach even trickier. 

Cleverly (thought I) I could make a sort of poor man's remote control by attaching wooden control dowels to the shifter lever and the twist throttle (using a commercial throttle extender).  Holes were drilled into the cockpit bulkhead and the dowels extended slightly into the cockpit.  Thus, without so much as standing up I could control the shifting and speed from the cockpit.  This system worked great for general motoring but it fell short in that the motor was now locked into position on the centre line of the boat and could not longer be pivoted to manoeuvre in tight quarters.  This is a definite disadvantage considering the poor reversing and stopping characterists of this Chebacco/OB combination.

Remote shifter 1.0 one end...
...and the other
Back to the drawing board as they say.  Jamie Orr has the same motor on his boat, Wayward Lass.  He added a short extension to the shifter that allowed him to shift by reaching over the top of the motor to shift gears.  When motoring in tight quarters Jamie would perch on the port aft deck and be able to control shifter, throttle and tiller handily.  This arrangement allows the motor to still pivot when required for tight manoeuvring.  Clever chap that Jamie, so I copied him.  My lever extension was in fact the plastic extended socket wench thingy that came with  my new kitchen faucet and it fit perfectly.  Never throw anything out.

Remote shifter 2.0

A keen observer may notice in the top two photos the extension to the motor pull cord.  As with the shifter -the mizzen, rudder post, main sheet traveller and the distance to the transom from the cockpit make pulling the starter cord a challenge and a risk to back, elbows and fingernails.  Very considerately, when purchased, the Honda OB came with a back up starting cord to be used in the unlucky event of cord breakage or failure of the ratchet mechanism.  This cord is attached to the rubber hand grip of the built in starter cord and reaches easily to the cockpit.  Simple and slick.

No comments:

Post a Comment